Tuning & Engine Management

Manifold Absolute Pressure (MAP) Sensor for First Generation Pro-Flo Systems)

The Edelbrock #3587 is a 1-Bar MAP sensor for use with first generation Edelbrock Pro-Flo EFI systems.

2 Bar Manifold Absolute Pressure (MAP) Sensor for Pro-Flo 2 Systems

The Edelbrock #36020 Pro-Tuner EFI Pressure Sensors are intended to be used with Edelbrock's Pro-Tuner EFI system, but may be used with other systems using the supplied connector and wiring.

MAP Sensor 3-bar for blown/turbo applications

• Applications up to 30lbs of boost.

MAP Sensor - 3 Bar Vacuum to 30PSI

• This sensor monitors manifold vacuum, varying output voltage to the ECU as a function of load placed on the engine…
• Highly accurate design

MAP Sensor Assembly for Atomic TBI

Atomic TBI factory replacement MAP sensor.

1-Bar MAP Sensor #36021 for Chevy LS3 applications

The new Edelbrock 1-Bar Manifold Absolute Pressure (MAP) Sensor #36021 is designed to fit Chevrolet LS3 applications that use an Edelbrock LS3 XT intake manifold or any other factory-style intake that has a 12mm MAP sensor port hole.

MAP Sensor 2-bar for blown/turbo

• Applications up to 15 lbs of boost.
• Stock connector.

MAP Sensor 2-bar for blown/turbo applications

• Applications up to 15 lbs of boost.
• For use with MSD controls.

MAP Sensor 3-bar for blown/turbo

The pressure inside the intake manifold is an extremely important input to the ECU.

Manifold Absolute Pressure Sensor #3542 Upgrade For ProFlo4 Boosted Applications

Edelbrock part #3542 is a 2-Bar MAP sensor is an upgrade component for use with ProFlo4 boosted applications.

Manifold Absolute Pressure Sensor #3547 Upgrade For ProFlo4 Boosted Applications

Edelbrock part #3547 T-MAP Sensor Conversion Harness Kit is to install a single combination Inlet Air Temp (IAT) & Manifold Absolute Pressure (MAP) sensor in place of existing separate IAT and MAP sensors.