Engine Sensors

Transmission Controller Distributor Adapter Harness

Electronics Accessories

1000 PSIg Stainless Sensor Kit

• Includes 1/8" NPT to -4 AN adapter included
• Stainless-steel sensors accurate to within 1% of full scale (pressure sensors)
• Connector and pins included

100 PSIg Stainless Sensor Kit

• Stainless-steel sensors accurate to within 1% of full scale (pressure sensors)
• Connector and pins included
• Analog Data Scaled in Charts

1-Bar MAP Sensor #36021 for Chevy LS3 applications

The new Edelbrock 1-Bar Manifold Absolute Pressure (MAP) Sensor #36021 is designed to fit Chevrolet LS3 applications that use an Edelbrock LS3 XT intake manifold or any other factory-style intake that has a 12mm MAP sensor port hole.

Atomic TBI, Fuel Pressure Sensor

Atomic EFI Support Component

Bosch Replacement UEGO Sensor

• Never requires free-air calibration when used with an AEM Controller and connector plug.
• Connector and pins included
• Replacement sensor only

DTM-Style Air Temp Sensor Kit

• Weatherproof connector
• Connector and pins included
• Analog Data scaled and charted

EAS Replacement EGT LEAD - 15 Inch

• EAS Accessory
• Easy Plug and Play
• Monitor EGT's with your device

EAS Temperature Sensor - -40-300 Degrees Fahrenheit

• Monitor temps on your vehicle
• -40° - 300° Range
• Easy Setup with EAS

Ethanol Content Flex Fuel Sensor Kit

• 6AN fittings.
• Connector, terminals, and wire seals included
• Measures ethanol content and fuel temperature

K-Type Closed Tip Thermocouple

• Comes with everything you need
• Includes K-Type Closed Tip Thermocouple, Inconel sheath, 1/8" NPT compression fitting, 10-foot extension harness
• Sold individually

K-Type Thermocouple 10' Extention Harness

• Cut to Fit Extension
• 2 X 4-40 Hex Nut, 2 X 4-40 Screw & 6" Heat Shrink Tubing
• Sold Individually

MAP Sensor 2-bar for blown/turbo applications

• Applications up to 15 lbs of boost.
• For use with MSD controls.

Pro-Flo 3 Fuel Sensor (1/8" -27 NPT)

Edelbrock part #3546 for Pro-Flo 3 Fuel Sensor, It includes a 1/8-27 NPT fuel pressure sensor with a -6 AN fuel pressure take-off fitting

Pro-Flo EFI Air Temperature Sensor 3/8"-18 NPT Thread

The Edelbrock #3588 Air Temp Sensor with 3/8"-18 NPT threads.

QTY 2 K-Type Closed Tip Thermocouple

• Comes with everything needed to attach to our CAN EGT Module
• Includes K-Type Closed Tip Thermocouple, Inconel sheath, 1/8" NPT compression fitting, 10-foot extension harness
• Sold as a pair

SENSOR; BOOST/FUEL PRESS; 0-60PSI; 1/8in. NPT MALE

• Built In Connector Mates To Delphi Packard Metri-Pack
• 150 Series Connector [12065287-Not Included]

SENSOR; FLUID PRESSURE; 0-30PSI;-4AN MALE

• Ashcroft; Fuel Pressure Sender

SENSOR; PRESSURE; SPEK-PRO; 100/120/150 PSI; 1/8in. NPT MALE (EXCL. BOOST)

• Built In Connector Mates To Delphi Packard Metri-Pack
• 150 Series Connector [12065287-Not Included]

Temperature Sender 1/8" NPT

Temp Sender 1/8" NPT

Temp Sender 1/8" NPT Low Temp

Quality, Service and Value are not new to us.

Temp Sender 3/8" NPT Low Tempature Gauge

Quality, Service and Value are not new to us.

ATOMIC TBI, COOLANT TEMP SENSOR

• Replacement coolant temperature sensor for Atomic EFI system

MAP Sensor 2-bar for blown/turbo

• Applications up to 15 lbs of boost.
• Stock connector.

Oil Pressure Sender (100 PSI)

Oil Pressure Sender 100 PSI