Engine Control Modules

Sensor Docking Station w/Pyrometer Probe

• Sensor Docking Station

VCU 300 Programmable Electric Vehicle Control Unit

• Primary functions of the AEM VCU300 include:
• Redundancy and arbitration features for all safety-critical inputs
• Accessory control of cooling pumps, cooling fans, lights and more

Sensor Docking Station

The Bully Dog Sensor Docking Station is a great, and easy way for you to check on the well-being of your vehicle.

Eliminator 4-Bank Chip Burner

• DTC Reading And Clearing Capabilities
• Allows For Specific And Accurate Tuning

Front Low Voltage VCU300 Harness

• Braided harness.
• Label with color coded wires.
• Prewired communications port.

Gateway Bypass Harness

• bypasses factory gateway module
• instals behind dash
• connects to STAR connectors

VCU 275 - Plug & Pin Kit

• Waterproof connectors
• Quick-connect connectors
• Weatherproof seals to keep contaminants out

VCU275 Programmable Electric Vehicle Control Unit

• Full Integration of all EV sub-systems under one controller
• Accessory control of cooling pumps, cooling fans, lights and more
• Supports up to 2 Drive Motors and up to 1200V AEM BMS18 Systems

AEMnet CAN Hub

• Daisy chain two Hubs to connect six AEMnet Devices
• Compact enclosure - 3.45" (87.63mm) Long x 1.18" (29.85mm) Tall
• Safe for engine bay mounting - IP67-rated enclosure

Battery Management System Master

• Can be daisy chained to multiple satellite units
• Capable of measuring up to 18 cells and 3 temperatures (thermistors)
• Weatherproof connector and housing

Battery Management System Satellite

• Connected to Master BMS as part of system
• Can be integrated into multiple satellite systems
• Weatherproof connector and housing

Power Grid 4-Connector Hub

This hub allows you to expand the Power Grid system with up to four accessory modules.

Power Grid 4-Connector Hub - Black Housing

This hub allows you to expand the Power Grid system with up to four accessory modules.

CAN-Bus Termination Cap

• For use with Power Grid Controller
• 4-Connector CAN-Bus Hub required

Engine Control Unit (ECU) #3543 for the Pro-Flo 4

For those of you who are running a Pro-Flo 4 EFI on your vehicle and have a damaged ECU, Edelbrock is now offering a replacement unit.

Front Low Voltage VCU275 Harness

• Braided harness.
• Label and color-coded wires.
• Prewired communications port.

Thruster T

• Reduce Lag Time And Increase The Vehicle Acceleration
• Use The Control Knob To Change Performance On The Fly
• Built For Off Road Fully Waterproof Design